Valve Selection Guide

Butterfly Valve Sizing: DN/NPS, PN/Class, Face-to-Face and Bolt Patterns
2026-10-16
A butterfly valve is not interchangeable just because two valves have the same nominal diameter. Four dimension families must match: nominal size, pressure rating, face-to-face length, and flange drilling or bolt pattern. If any one of them is wrong, the valve may not fit between the flanges, may not match the pipe bolts, or may not be rated for the operating pressure.
Butterfly Valve Selection Checklist: 12 Data Points for an Accurate RFQ
2026-10-15
A vague butterfly valve inquiry produces a vague quotation. Most RFQs arrive missing two or three pieces of information that change the valve size, seat material, actuator, testing requirements, or price. The result is a longer quotation cycle, a proposal that may not match the project, or a valve that is ordered for the wrong service.
What Is Stop Shoulder Locating for a Vulcanized Seat on a Butterfly Valve?
2026-09-17
A vulcanized seat butterfly valve has its resilient rubber seat cured and bonded directly to the valve body. For the seat to seal correctly over thousands of cycles, it must stay in exactly the right position during molding, assembly, and operation. The stop shoulder, also called a locating shoulder or seat stop, is the machined shoulder inside the body that positions the vulcanized seat, controls how much the seat compresses, and protects it from being over-loaded by the disc.
Metal Seated vs Resilient Seated Butterfly Valve: Which One to Choose
2026-09-07
The seat is the most application-sensitive component in a butterfly valve. It determines how the valve seals, its temperature limit, chemical compatibility, leakage class, operating torque, maintenance interval, and ultimately its total installed cost.
Concentric AWWA C504 vs Double Eccentric Butterfly Valve: A Practical Comparison for Waterworks
2026-08-27
For large-diameter water pipelines, treatment plants, and pumping stations, both concentric and double eccentric butterfly valves appear regularly in project specifications. Both can be used in waterworks service, but they solve different engineering problems. A concentric AWWA C504 butterfly valve is a resilient-seated, centered-shaft design built around simplicity and economy.
Sealing Principle of Centerline Rubber Seal Butterfly Valve
2026-08-13
How centerline butterfly valves seal: interference fit, seat compression, stem loading, torque analysis, and temperature limits by seat material EPDM, NBR, PTFE, Viton, Silicone.
The U-Section Flanged Butterfly Valve Install on Pipe
2026-08-05
Unlike a wafer valve that is merely "sandwiched" between flanges, the U-section flanged butterfly valve uses captive nuts housed inside the valve body's U-slot to engage fully threaded stud bolts. This allows the valve to be securely clamped to either pipe flange independently — delivering true dead-end service where one side of the pipeline can be disconnected while the other remains pressurized.
Wafer vs Lug vs Double Flange Butterfly Valve: Complete Design, Installation & Selection Guide
2026-08-04
Selecting the wrong butterfly valve body style can lead to installation headaches, leakage at the flange joint, or costly rework during plant shutdowns. This guide breaks down the structural differences, installation requirements, pressure limitations, and cost trade-offs between the three dominant butterfly valve body types — wafer, lug, and double flange — so you can specify the right valve for every piping application.
Wir verwenden Plätzchen um Ihr Online-Erlebnis zu verbessern. Indem Sie diese Website weiterhin nutzen, gehen wir davon aus, dass Sie unserer Verwendung von Plätzchen Die